Solid Carbide Router Bit – Spiral Compression 1 Flute Fashion

Solid Carbide Router Bit – Spiral Compression 1 Flute
Solid Carbide Router Bits
Each router bit has been precision ground from a single piece of super micro-grain solid tungsten carbide. This ultimate micro-grain carbide formulation gives the longest tool life and edge retention ensuring a very clean and accurate cut that leads to the ultimate finish. These STC router bits are suitable for use on softwoods, hardwoods, veneers, plastic materials, laminates, and composite materials.

Spiral Compression One Flute Bits
Spiral compression one flute bits feature both up and down shear cutting edges on the same bit. This combination provides down-cutting on the top faces of material and up-cutting on the bottom. This action pulls fibres towards the centre of the board, eliminating tearing & chipping, whilst ensuring an ultra fine finish on both faces. The one flute design of these bits is chosen when a faster cutting speed and increased feed rate is required, machining more material in less time. These bits are ideal for double faced veneered, laminated & melamine boards and other abrasive material.

Superior Finish and Performance
Each spiral has been specifically designed to give the optimum cutting angle to ensure the wood is sheared cleanly as well as providing efficient chip ejection. This leads to the bits running cooler during use as solid carbide dissipates heat more uniformly, even at high speeds, meaning the edges remain as sharp as possible and are retained for longer. Each bit conforms to strict German DIN standards to ensure maximum operator safety. ©